View Full Version : Help with no sound via FME
11-14-2009, 01:04 AM
During the week I had computer failure, so I had to rebuild my system. I was using XP, but now Im using Vista.
I have been streaming with a EzCap USB Device, which has been working fine. However, Now when I load FME up and select my Audio device, which is the USB audio device. I get no sound come though. I have dont the crossbar thing and still nothing. I dont even get the volume indecators come up!
Of any1 has any advice for me Id be much gratful
11-14-2009, 01:13 AM
Easycap, is not the best capture card in the world, and actually does't come with audio Drivers. Hopefully this thread (http://community.justin.tv/forums/showthread.php?t=96) should help (The thread is about the dazzle capture card, but it apply s to all capture cards that have the problem.)
11-14-2009, 02:01 AM
I think you were lucky to get sound working on that thing in the first place. most of the time caster connect direct to the line-in or mic jack on there sound card.
I guess play with drivers, and i am sure you can get it if you did it once before.
11-14-2009, 12:58 PM
SO can any1 tell me what device is best to get? Im now running Vista and Ideally need an external USB Device?
11-14-2009, 01:04 PM
Most people go with Dazzle, if you want a USB capture card. Be aware, that the dazzle can also have Audio Problems, but nothing that can't be fixed, same with easycap, if you check that link I posted, it should work. :)-
11-14-2009, 01:49 PM
This is step up for most of the people casting here:
You do not have to have the mixer. Just go directly to your line-in.
11-15-2009, 12:23 AM
Or, the JTV Wiki Page ;)
Also, a good place to start would be here (http://www.justin.tv/help_resources). :)
11-16-2009, 01:39 AM
let us know what happens. this question comes up from time to time.